HTC 10 (htc-pme)

Features
Flashing Whether it is possible to flash the device with pmbootstrap flasher.	Partial
USB Networking After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system).	Works
Internal storage eMMC, SD cards, UFS...	Untested
SD card Also includes other external storage cards.	Untested
Battery Whether charging and battery level reporting work.	Untested
Screen Whether the display works; ideally with sleep mode and brightness control.	Untested
Touchscreen	Untested
Multimedia
3D Acceleration	Untested
Audio Audio playback, microphone, headset and buttons.	Untested
Camera	Untested
Connectivity
Wi-Fi	Untested
Bluetooth	Untested
GPS	Untested
Modem
Calls	Untested
SMS	Untested
Mobile data	Untested
Miscellaneous
FDE Full disk encryption and unlocking with unl0kr.	Untested
USB OTG USB On-The-Go or USB-C Role switching.	Untested
Sensors
Accelerometer Handles automatic screen rotation in many interfaces.	Untested

HTC 10
Manufacturer	HTC
Name	10
Codename	htc-pme
Released	2016
Type	handset
Hardware
Chipset	Qualcomm Snapdragon 820 (MSM8996)
Display	1440x2560
Storage	32GB
Memory	4GB
Architecture	aarch64
Software
Original software The software and version the device was shipped with.	Android 6.0.1
Extended version The most recent supported version from the manufacturer.	Android
FOSS bootloader	no
Nura
Category	archived
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline.	no
pmOS kernel The kernel version that runs on the device's port.	3.18.31
Device package	device-htc-pme
Kernel package	linux-postmarketos-qcom-msm8996

This device has been archived. This means that it no longer appears in pmbootstrap and is likely broken.
It can still be selected in pmbootstrap init by typing in the vendor and codename, but you will have to build the kernel package manually.

Contributors

stev47
Medusa

Users owning this device

Segfault (Notes: Nearly unusable battery)
Stev47

How to enter flash mode

Boot while pressing "Volume Down".

Installation

$ pmbootstrap init # vendor: htc, device: pme
$ pmbootstrap install

Put the device into flash mode and run

$ pmbootstrap flasher flash_rootfs
$ pmbootstrap flasher flash_kernel

Note that pmbootstrap flasher boot will not work on this device.

Hardware

Component	Model	Status	Module	Notes
SoC	Qualcomm MSM8996 Snapdragon 820	Y
GPU	Qualcomm Adreno 530	Y	?	Should work, including venus
Display	Tianma with Himax HX8396-C2 controller	N	-	Some variants might use Sharp display, no driver in mainline
Touchscreen controller	Synaptics S3708	Y	rmi4
eMMC	SanDisk DF4032	Y	sdhci	EU variant, 32GB
Audio	Qcom WCD9335, NXP TFA9888	?	-	Speaker amp will need to be re-written, datasheet available
Wi-Fi	Broadcom BCM4359C0	?	brcmfmac	PCI-E device
Bluetooth	Broadcom BCM4349B1	?	btbcm
Modem	Qualcomm MSS	?
NFC	NXP PN548AD	?	pn544
USB MUX	Analogix ANX7418	N	?
USB-C HDMI	Analogix ANX7816	N	anx78xx	Requires FW, needs to be defined in kernel module (same i2c registers as anx7818)
Front camera	Samsung S5K4E6	N	-	No driver
Rear camera	OmniVision OV12890	N	-	Seems like Sony IMX377 might be used in some variants
PMIC	Qualcomm PM8996	?	?
Fingerprint	FPC1155 (FPC1020?)	?
Hall effect	Asahi Kasei AK8789	?	?
Proximity	STMicroelectronics L53L0	?	?

Debugging

If the device hangs, press and hold vol_down + power. LEDs under the display will flash 15 times and device will reboot.